22
Adjusting settings via the operating menu
The extended menu “Advanced Menu”
Setting the transmission frequencies for the frequency banks
“U1” to “U6” – “Tune”
Via the “Tune” menu item, you can:
1. set a transmission frequency to be stored in the current channel of the
frequency bank (“U1” to “U6”)
2. or select a frequency bank (“U1” to “U6”) and a channel and assign this
channel a transmission frequency.
Setting a transmission frequency for the current channel
̈ Set the desired frequency.
When you have selected one of the system banks and then select
the “Tune” menu, the plug-on transmitter automatically switches
to channel 1 of the frequency bank “U1”. In this case, “U1.1”
briefly appears on the display panel.
Upon delivery, the channels of the frequency banks “U1” to “U6”
are not assigned a transmission frequency.
When you are in the “Tune” menu item, the RF signal is
deactivated.
It is vital to observe the notes on frequency selection on page 26.
̈ Press the UP/DOWN button until the “Tune” menu item
appears.
̈ Press the SET button.
The frequency selection appears.
̈ Press the SET button.
Your settings are stored. The “Tune” menu item appears.
SET
543 .850 MHz
Tune
543.850MHz
B.Ch: U. 1 B.Ch: U. 1
Tune
Advanced
Menu
Tune
“Stored”
Select the MHz
value and confirm
Select the kHz
value; store the
setting
Call up “Tune”
SET
