Filter
Top Products
4
Front Panel Functions and Operation
1. POWER: Press this button to toggle the KOD-
1000 on and o. Turning o the power on the player’s
front panel, however, will not allow it to be powered
on by the remote control.
2. NUMERIC KEYS: Press these buttons to input
track selections and song numbers.
3. PLAY/PAUSE: Press this button to begin playing;
press again to pause and press it again to resume.
4. STOP: Press this button to stop playing the selec-
tion.
5. OPEN/CLOSE: Press this button to open or close
the disc tray.
6. L/R: Press this button to isolate the left or right
audio channel, or to select mono or stereo output for
DVDs and CDs.
7. DISC TRAY: To open, press OPEN/CLOSE.
Place the disc in the tray. Press OPEN/CLOSE again
or the PLAY/PAUSE button to close. e disc should
play immediately.
8. DISPLAY WINDOW: Time, disc format or song
number is displayed here.
9. MENU: Press this button to display categories in
Hard Disk Drive Mode and a chapter list when play-
ing a DVD.
10. USB INTERFACE: is interface allows the
KOD-1000 to access mass storage devices such as
USB/ash/thumb drives as long as they are formatted
as FAT32 (See Page 6 for more information).
11. DIRECTION: Use these button to navigate on
screen menus.
12. MIC 1 & 2 JACKS: ese jacks connect micro-
phones to the KOD-1000 through 1/4 inch plugs.
13. ENTER: Press this button to conrm selections.
14. MIC 1 & 2 VOLUME KNOBS: Use these knobs
to control the volume of the microphones.
Back Panel Functions and Operation
1. ELECTRIC PLUG: An auto-detect power supply
(100-240 V, 50-60Hz) connects to alternating current.
2. VGA PORT: is port connects the KOD-1000 to
a computer monitor. e RCA Video out will con-
tinue to work if the VGA port is enabled. For more
information about using this port, see Page 7.
3. PS/2 KEYBOARD: is port connects to a com-
puter keyboard. For more information, see Page 7.
4. OPTICAL OUTPUT: is connection is used
for 5.1 surround sound (Dolby Digital and DTS). e
SETUP menu must be set for this output. See Page
22 about setting up the optical output. Microphones
don’t work when this output is in use.
5. COAXIAL OUTPUT: is connection is used for
5.1 surround sound (Dolby Digital and DTS). e
SETUP menu must be set for this output. Micro-
phones will not work when this output is in use.
6. S-VIDEO OUTPUT: is connection is for the
s-video output. It is of better quality than the RCA
Video Output, but not as good as the component
output. See page 21 to set this output.
7. COMPONENT OUTPUT: is connection is
usually found on high denition televisions. Change
Video setting to INTERLACE-YUV before connect-
ing a component cable or no picture will show on TV.
See page 21 for more information.