Filter
Top Products
AdderLink Installation and Use Page 20
2. Video compensation / configuration mode (see section 2.8)
This mode is entered by typing the hotkey combination (selected using the option
switches) on the keyboard attached to the XR receiver. Once within video
compensation / configuration mode you can adjust the video compensation and
select other options using the keyboard. The selected options are saved and stored
in the XR unit when you exit compensation / configuration mode.
2.6 Setting the option switches
The option switches on the side of the AdderLink XR and XL units are used to select
operating options. The switches are continuously read by the AdderLink and may be
changed whilst the AdderLink is powered on. The default setting (all switches OFF)
is suitable for most installations. The switches are shown in figures 6 and 7 and
have the following functions.
XR unit - Switches 1 to 5
Reserved – set to OFF position
XR unit - Switches 6 to 8
These switches select the hotkey combinations that are recognised by the
AdderLink. The chosen hotkey combinations are used to enter compensation /
configuration mode, lock the AdderLink, disable the AdderLink’s video and select
between local and remote computers on the AdderLink Gold.
XL unit – Switch 1
This switch may be used to reset the XL unit without disconnecting the power. In the
OFF position the AdderLink will operate normally. In the ON position the AdderLink
will suspend all operation and reset itself to the power off condition. Cycling the
switch from the OFF position to the ON position and back to the OFF position again
will perform a reset without having to disconnect the keyboard lead and power lead.
XL unit - Switches 2 and 3
Reserved – set to OFF position
XL unit - Switch 4
This switch should normally be set in the OFF position and should only be set ON if
you are connecting a laptop computer using a 'Y' cable or adapter. These 'Y' cables
and adapters are used to connect a PS/2 mouse and keyboard to the single 6-way