Filter
Top Products
AdderLink Installation and Use Page 36
‘HOTKEYs’ and ‘L’ - Disconnects the AdderLink XR’s keyboard and mouse from
the computer that they are controlling and switches off all the red status lights. The
video signal is switched off. If a password has not been set then the AdderLink can
be re-enabled by selecting a computer using ‘HOTKEYs’ and ‘TAB’ or ‘HOTKEYs’
and ‘1’ (or ‘HOTKEYs’ and ‘2’ on the AdderLink Gold). If a password has been set
then the AdderLink will alternately flash the NUM and SCROLL and then the CAPS
lock lights on the keyboard connected to the XR unit. This indicates that a valid
password must be entered to unlock the AdderLink. Simply type the same key
combination as was set during configuration (see section 3.10) followed by the
RETURN key. Note - if anyone has typed at the keyboard whilst in secure mode, it
will be necessary to type RETURN first to clear the invalid password, then type the
valid password followed by RETURN again.
‘HOTKEYs’ and ‘1’ - selects the remote computer attached to the XL unit
‘HOTKEYs’ and ‘2’ - selects the local computer attached to the XR unit (AdderLink
Gold only)
‘HOTKEYs’ and ‘TAB’ – Selects the next computer (remote or local)
‘HOTKEYs’ and RETURN – Enters video compensation / configuration mode
Examples of common hotkey sequences (assuming CTRL + ALT hotkey option):
To lock the AdderLink
press
baba
LL release LL
baba
To 'tab through' computers (AdderLink Gold):
press
baba
vv
release
vv
press
vv
release
vv
press
vv
release
vbavba