Filter
Top Products
2
A Tour of the MultiMix USB2.0
14
Line Inputs (Channels 9 – 16)
Unlike channels 1 – 8, the line inputs on channels 9 – 16 are stereo
inputs that have left and right inputs. If you’re using one of these
channels as a mono input, plug your instrument into the left input.
Channels 9 – 16 don’t have the extra gain found on channels 1 – 8
because most line-level instruments don’t require the extra boost.
Synthesizers and other electronic instruments will work especially
well on these channels. These inputs are also good for connecting
CD players or tape decks, as these audio sources don’t require
extra gain.
PHONE Jack
The headphone jack accepts 1/4” jacks. If your headphones are
1/8”, you can find a 1/8” to 1/4” adapter in most electronics
stores.
AUX RETURNS
These are the 1/4” jacks where you connect the outputs of an
external effects processor or other audio source. Each aux return
gives you 15dB of gain that can be controlled by the AUX RET A
and EFFECTS / AUX RET B LEVEL knobs in the mixer’s
output section.
AUX SENDS
And this is the 1/4” jack where you connect the cable that’s going
into the input of an external effects processor. The aux sends give
you 10dB of gain that can be controlled in the AUX section of
each channel input.
ALT 3/4 OUT
These jacks are the outputs for the MultiMix’s extra stereo bus.
This signal includes channels whose MUTE / ALT 3/4 switch is
activated.
2-TRACK
The 2-TRACK IN and OUT jacks are standard RCA jacks. You’ll
use the OUTs for mixing to a tape deck or other recorder. With
the INs you can bring in a signal, which can be monitored and
even added to the main mix via the 2TK TO MIX switch in the
master section of the mixer.
The 2-TRACK INPUT is blended with any signal coming back
from a computer over the USB2.0 connection.
MAIN MIX OUT
These 1/4” jacks are where the signal on the main mix bus leaves
the mixer. From there you can send it to a recorder or a PA system.
The level of this signal is controlled by the MAIN MIX fader.
I
f you are using an effects
device with only a mono
output, plug it into the left
return of STEREO AUX
RETURN. It will appear in
the center of the stereo
spectrum, and not to the left.
A
ny audio signal that is
routed to the MAIN
OUTPUTS will also be sent
out of the DIGITAL OUTPUT
jack. The level is controlled
by the MAIN FADERS. The
DIGITAL OUTPUT mirrors
the output from the MAIN
OUTPUTS.