Filter
Top Products
6 Editing Programs
19
To Edit a Selected Program
1. Select a program to edit using the
foot pedals or VALUE knob.
2. Turn the EFFECT knob to the
effect module or parameter you
wish to modify.
3. Turn the VALUE knob to select
an effect type or value for the
module. As soon as you change
the value, the EDITED decimal
point on the display lights up to
show you a change has been
made to the current program.
4. If the module has a parameter
such as DRIVE or PARAM,
turn the EFFECT knob to
select the parameter.
5. Using the VALUE knob, select a
value for the parameter.
6. Continue in this way until you have completed
assignments for all modules and parameters.
To Restore Factory Presets
Once you have saved changes to a preset program, you can
still recall the original settings. To enter RESTORE
FACTORY PRESETS mode, simply hold down the VALUE
knob as you turn the unit on and then select the program to
be restored (or
for all programs). Press the VALUE
knob to confirm your selection. Any program changes you
have made will be lost, so you might want to copy the
program to another location first. See chapter 8 for
instructions on copying programs.
Just turn the EFFECT
knob to exit the
RESTORE FACTORY
PRESETS mode, or
turn the unit off and
then on again.
1
1
2
3
4
5
To toggle an effect
module on and off,
press both pedals while
the effect module is
selected.