Filter
Top Products
also change chase patterns normally. To activate this function press and
release the MANUAL STEP (26) while holding down the SHIFT BUTTON
(16). The LCD DISPLAY (6) MANUAL STEP LED will light, indicating
this function has been activated. To exit this function press the CHASE
BUTTON (24) at any time.
Fade Time Function: This function can be operated in any normal
chase function. This function allows you to control the amount of time it
takes for one scene to switch off and the next to turn on. Basically one
scene fades to the next. The amount of fade time varies from instant to
10 minutes. This function is controlled by the FADE TIME SLIDER (7) and
only effects the dimmer channels (1-8). When the FADE SLIDER is set
to zero the amount of time it takes for one scene to fade to the next will
be instant, when the fader is set to 10, it will take about 10 minutes to
fade from one scene to the next. To activate this function move the FADE
TIME SLIDER (7) up and down during any normal chase function.
Midi Settings: This controller can be triggered by any type of MIDI
device. To use the MIDI function, plug in a standard MIDI controller to the
MIDI input jack (35) on the rear of the Light Station.™ When your unit is
receiving a MIDI signal the yellow MIDI SIGNAL LED will begin to ash
rapidly. To operate properly the MIDI input channel must match that of
the controller MIDI receiving channel. The controller’s default MIDI input
signal is one, you may nd it necessary to change this setting if you are
running several MIDI devices. To adjust the controllers input MIDI signal
hold down the MIDI CHANNEL BUTTON (27) for two seconds while hold-
ing down the SHIFT BUTTON (16). “CH:01” will appear in the LCD DIS-
PLAY (6). Use the STEP UP and DOWN BUTTONS (20 & 21) to change
the input if necessary. Below you will nd the MIDI NOTE DATA:
Note Number Velocity Function
22-81 Master Pattern Level Turns Patterns 1-60 On & Off
82-97 Channel Dimmer Identical to the Flash Channels 1-16
99 Full ON
101 Execute the patterns step by step
102 Engages and disengages STAND BY mode
Please note when use a MIDI controller the LEVEL SLIDER (8) will
not function.
Controller Reset and Memory Dump: This board may be reset
to factory settings at any time. You may use this function to erase all
your programs. This function may also be used to eliminate any system
FREEZE.
Caution: This operation may be harmful to the controllers internal Flash
Memory, please use this operation infrequently.
Options:
An optional foot controller may be purchased separately. This controller
will allow you to control some of the function by remote. With the foot con-
troller you may control pattern step up, pattern up, stand by mode, full on.
Please contact you American DJ dealer for pricing.
©American DJ Suply® www-americandj.com Light Stantion Instruction Manual Page 15 ©American DJ Suply® www-americandj.com Light Stantion Instruction Manual Page 16