Filter
Top Products
Pro Series 5 Installation and Operation
4
Transmitter Setup, Controls and Functions
Battery Selection and Installation
Two alkaline AA batteries are recommended. When inserting the battery,
observe correct polarity as marked inside the battery compartment.
Figure C — Handheld Transmitter
Handheld Transmitter Battery Installation
1. Unscrew the lower body cover, slide it downward, and remove it to
expose the battery compartment.
2. Observe correct polarity as marked inside the battery compartment
and carefully insert two fresh 1.5V AA alkaline batteries. Insert
the rst battery and slide it toward the spring contact. Then insert
the second battery into the space remaining. Make certain the
batteries are fully seated in the battery compartment. (Fig. C)
3. Slide the lower body cover back on and screw the housing together.
Do not overtighten.
Note: Remove batteries from the handheld transmitter starting at the
bottom end, where nger indents in the battery housing are provided
for easy grip.
Handheld Transmitter Battery Condition Indicator
After the battery is installed, press and hold the Power/Mute button
until the indicator LED turns green (Fig.C). (It will turn red rst; keep
holding until it turns green). If the indicator LED does not light up when
the Power/Mute button is pressed, the batteries are installed incorrectly
or they are dead. The LED will ash to indicate low-battery condition.
Handheld Transmitter Mute Function
With the transmitter on, a slight touch of the Power/Mute button will
toggle between muted and unmuted operation. Red LED indicates
muted operation. Green LED indicates unmuted operation.
Channel Selector
Switch
Trim Control
(Volume)
Screwdriver
Power/Mute Button
Indicator LED
(Power/Mute/Battery)
Battery
Compartment