Audio-Technica pro series 5 wireless systems Microphone User Manual


 
Pro Series 5 Installation and Operation
5
Figure D — UniPak
®
Transmitter
UniPak
®
Transmitter Battery Installation
1. Open the transmitter door by rst pulling the catch down and then
sliding the door upward (Fig. D).
2. Observe correct polarity as marked and carefully insert two fresh
1.5V AA alkaline batteries (Fig. D).
3. Slide the door closed, making certain it clicks securely in place.
UniPak
®
Transmitter Battery Condition Indicator
After the battery is installed, press and hold the Power/Mute button until
the indicator LED turns green (Fig.E). (It will turn red rst; keep holding
until it turns green). If the indicator LED does not light up when the
Power/Mute button is pressed, the batteries are installed incorrectly or
they are dead. The LED will ash to indicate low-battery condition.
UniPak
®
Transmitter Mute Function
With the transmitter on, a slight touch of the Power/Mute button will
toggle between muted and unmuted operation. Red LED indicates
muted operation. Green LED indicates unmuted operation.
UniPak
®
Transmitter Input Connection
Connect an audio input device (microphone or guitar cable) to the
audio input connector on the top of the transmitter. A number of
Audio-Technica professional microphones and cables are available
separately, pre-terminated with a UniPak
®
input connector (see www.
audio-technica.com.)
UniPak
®
Transmitter Antenna
The UniPak
®
transmitter includes a permanently-attached exible
antenna. For best results, allow the antenna to hang freely and
full length from the transmitter. If the received signal is marginal,
experiment with different transmitter positions on your body or
instrument; or try repositioning the receiver. Do not attempt to
remove, replace or change the length of the transmitting antenna.
Figure E — UniPak
®
Transmitter
Antenna
Input
Connector
Indicator LED
(Power/Mute/Battery)
Power/Mute Button
Channel Selector
Switch
Transmitter Door
(Open Positon)
Screwdriver
RF Power
Select Switch
Instrument Trim
Control (Volume)
Microphone Trim
Control (Volume)
Transmitter
Door Catch
Transmitter
Door