Filter
Top Products
Aviom A-16II Personal Mixer User Guide
28
Making Changes to a Group
Once you have created a Group, you can edit it in a number of ways. You
can add or delete Channels from the Group, and change individual Channel
volume and pan settings.
To change a Group, start by selecting a Channel that is already part of a
Group. All Channel LEDs that are part of the Group will light. Press the
G
ROUP button to enter the editing mode. The Group LED flashes.
Changing Channel Settings Within a Group
While editing a Group, you’ll notice that one LED in each Group is lit solid
while the other LEDs are flashing. This solid LED indicates the Channel
currently selected for editing. You can change its volume and panning
without affecting the other components of the Group. The changes you
make to volume and pan affect only the selected Channel, allowing you to
change the relative balance of the individual components of your Group.
Changes can be made in real time.
To select a different Channel in a Group for editing, press one of the
flashing LEDs (don’t double-click it). The new selection will light its LED
solid, while the previously selected Channel will start to flash. Continue
making changes as needed. Remember, volume and pan changes only affect
the Channel whose LED is lit solid. Press the GROUP button again to exit
Group Mode.
Removing Channels From a Group
When in the Group edit mode (the Group LED is flashing), changes can be
made to the existing Groups. To remove a Channel from a Group, simply
double-click the Channel that you want to remove. The flashing LED will
go out. To add other Channels to a Group, double-click them. When you
have double-clicked to remove all Channels that were previously part of the
Group you’re editing, the Group will no longer exist. You need at least two
Channels to have a valid group.
Exit the Group edit mode by pressing the G
ROUP button again. The LED in
the Group button will go out. This saves your changes to the Group.
Some points to note about Groups:
• Up to three Groups can be created per Preset.
• Groups are relative only to the Personal Mixer that they are
created on.
• Groups you create on your Personal Mixer do not affect
other Personal Mixers being used in your system.