Filter
Top Products
26
MH10 c
oNFigurAtioNs
all audio inputs from the stage (ports 1-8) for use in a monitor console
or in a recording or broadcast room.
All Cat-5e network cables shown in the example diagrams can be up to
400 feet (120 meters) long. Fiber optic cable length will depend upon
the type of SFP device used (single- or multi-mode). Always use the
same type and specification SFP transceivers in each MH10f.
MH10 Configuration Errors
Data Loops
When using multiple MH10/MH10f Merger Hubs in a digital network,
never connect a pair of ports (two cables) between MH10/MH10f devices
other than ports 9-10 in Manual Mode Configuration C. Doing so will
cause an A-Net data loop. Only Manual Mode, and its Configuration C
specifically, can use a pair of Cat-5e or fiber cables connected between
ports 9 and 10 in a backup/redundant cable setup.
Changing from Manual Mode to Auto Mode
When changing from a Manual Mode setup using two MH10/MH10f
Merger Hubs in Configuration C to an Auto Mode setup, make sure
that the backup/redundant cable connected between port 9 or 10
on each MH10/MH10f is disconnected before changing the network
setup to avoid a data loop. Only one cable (Cat-5e or fiber) should be
connected between ports 9-10 when the MH10/MH10f is being used in
any configuration except Manual Mode Configuration C.