Filter
Top Products
23
E
5.3.1 Initial Settings For The Compressor Section
lortnoC gnitteS
hctiwsTUO/NINI
hctiwsTXECSTUO
hctiwsNOMCSTUO
hctiwsEVITCARETNINI
hctiwsRETLIFCSTUO
lortnocDLOHSERHTBd02+
lortnocOITAR1:3
hctiwsOTUANI
lortnocTUPTUOBd0
Tab. 5.2: Initial settings for the compressor section
Rotate the THRESHOLD control counterclockwise until an appropriate amount of gain reduction is indicated on
the GAIN REDUCTION meter. This operation will be accompanied by an audible drop in output level. The
OUTPUT control should now be turned clockwise to reinstate the output level. The level of the unprocessed and
the processed signal can be compared by pressing the I/O METER switch and observing the INPUT/OUTPUT
LEVEL meter.
Final adjustments of the controls can then be made to suit your particular requirements, including the RATIO,
ATTACK and RELEASE controls. The AUTO function of the attack and release times, provides program
dependent dynamic processing which suits most standard uses. If a condensed or wider sound processing
technique is required, the attack and release times can also be manually adjusted.
The experienced user will be in a position to specify parameters while in bypass mode and thus realize the
effect before the unit is actually switched into operation. This is important in live situations, where a signal
needs to be managed efficiently by the engineer, without the convenience of continual A/B comparison.
For using the AUTOCOM PRO as a Limiter, you should set RATIO to oo:1, INTERACTIVE to off and use short
Attack and max. Release Times. Use the THRESHOLD control to set the threshold level for limiting.
5.3.2 The AUTOCOM PRO As A Sound Effects Unit
In the early 1960s, musicians began looking at the recording process as a way to create new sounds. The
pumping effect which had been avoided by earlier engineers suddenly became fashionable and was utilized as
a creative tool, laying the groundwork for many of the sounds which are now considered indispensable in
contemporary music. The compressor is used in this role because you can hear it working, and control of the
dynamic range is of secondary importance.
The Behringer AUTOCOM PRO, with its extensive range of functions, is well suited to this application. Sound
effects of this kind can be achieved using extreme settings. To achieve this, set the THRESHOLD control to
a fairly low level, the RATIO control to almost maximum and use the ATTACK and RELEASE controls to obtain
the desired effect. Experiment with all the controls in order to get a feel of their function!
5.3.3 The Muffling Effect Of A Compressor
Quite often, compressors are sometimes accused of muffling the sound, whilst at the same time reducing the
dynamics. This fact should be investigated further. Bass frequencies contain most of the energy within music
and therefore cause the compressor to reduce the overall dynamics. If the music also contains high frequen-
cies along with the bass frequencies, these are also reduced in level. This is the reason why: in an extremely
compressed recording of drums, the cymbals and high-hats are acoustically swamped by the sound of the
snare or the bass drum. The same effect is experienced when processing reverberated or ambient sounds. The
solution commonly used to this basic problem is either to reduce the compression ratio or to slow down the
5.APPLICATIONS