Filter
Top Products
Selecting and Playing a Tone
E-19
1.
Press the L-10 (METRONOME) button.
• This will start the metronome.
• The display will show the tempo along with a count of
the measures and beats since you started the
metronome.
2.
Press the L-10 (METRONOME) button again to
stop the metronome.
1.
Hold down the L-10 (BEAT) button until the
metronome beat screen shown below appears
on the display.
2.
Use the dial or R-14 (–, +) buttons to select a
beat setting.
• You can select 0, or a value within the range of 2 to 6.
Specifying 0 for this setting will cause each beat to be
indicated by the same sound (no chime at the
beginning of each measure).
3.
Press the L-10 (BEAT) or R-15 (EXIT) button.
• This exits the metronome beat screen.
There are two different methods you can use to change the
tempo setting: using the TEMPO buttons or tapping a beat
with a button.
■To change the tempo using the TEMPO buttons
1.
Press the L-11 (TEMPO w) (slower) or L-12
(TEMPO q) (faster) button.
• This displays the tempo screen shown below.
• If you do not perform any operation for a few seconds,
the display will return to previous screen automatically.
2.
Use the L-11 (TEMPO w) and L-12 (TEMPO q)
buttons to change the tempo (beats per
minute).
• Holding down either button will scroll the setting values
at high speed.
• You can specify a tempo value in the range of 30 to
255.
3.
Press the R-15 (EXIT) button.
• This exits the tempo screen.
Using the Metronome
To change the beats per measure
Tempo
Measure
Beat
To change the tempo setting
CTK6000_e.book 19 ページ ２０１０年７月１２日 月曜日 午後１２時５０分