Filter
Top Products
E-30
Music Presets
7.
Use the
ct
(w, q) buttons to select the
Music Preset number where you want to
store the edited data.
8.
Enter a name for the preset.
Use the
dn
(u) and
do
(i) buttons to move the cursor
to the character you want to change and then use the
ct
(w, q) buttons to change the character. The following
shows a table of available characters.
• To input a space, press both of the
ct
(w and q)
buttons at the same time.
9.
Press the
dp
(ENTER) button.
This saves the data.
• If the preset number where you are saving the data
already has data saved to it, a message (Replace?) will
appear on the display to confirm whether you want
to replace the existing data with the new data.
Press the
ct
(YES) button to overwrite or the
ct
(NO)
button to cancel the save operation.
■ To edit the chord progression
1.
On the editing operation selection screen
(page E-29), select “CHORD” and then press
the
dp
(ENTER) button to display the chord
progression editing screen shown below.
(1) Step (timing and chord)
The timing of a chord progression is expressed as a
series of three values separated by colons (such as
001:1:00) indicating measure
*1
(001), beat (1), and
tick (00)
*2
. This series of three values is referred to
collectively as a “step”.
The screen shot above shows the first two steps
(001, 002) of the Music Preset. Use the
bp
(REW)
and
bq
(FF) buttons to scroll and view other steps.
*1 Up to 999 measures
*2 There are 12 ticks per beat, as shown below.
(2) Cursor
Specifies the step that is currently selected for
editing.
(3) Resolution
Resolution is a unit used when editing step timing.
The initial resolution is R1 (one measure), but you
also can select R4 (1 beat = 1 quarter note) when you
want to specify chords for each beat. Use the
instrument part buttons (
5
through
bm
) to select
one of the eight resolutions shown below.
(3)Resolution(2)Cursor
(1)Step (timing and chord)
01 02 09 10 1100
Chord progression
Measure 1
Beat 1 Beat 2 Beat 3 Beat 4 Beat 1 Beat 2
Tick
001:1:00
002:1:00
For the sample display
above, the chord change
from C to Bm occurs here.
Measure 2
3 3
R1 R2 R4 R8 R8T R16 R16T R32T
56789bkblbm
(1 measure) (2 beats) (1 beat) (1/2 beat) (1/3 beat) (1/4 beat) (1/6 beat) (1/12 beat)
PX780_e.book 30 ページ ２０１２年１２月６日 木曜日 午後２時２６分