Filter
Top Products
E-59
English
Assembling the Stand
PREPARATION
• Before starting assembly, check to make sure that
you have all the parts shown below. You can find
the screws in a plastic bag inside of the polystyrene
foam packing material.
• This stand does not include any of the tools required
for assembly. It is up to you to prepare a large
Philips head (+) screwdriver for assembly.
*CAUTION
• The stand should be assembled by two people
working together.
• The stand should be assembled on a flat surface.
• Do not remove the tape securing the keyboard cover
in place until assembly is complete. Removing the
tape can cause the keyboard cover to open and close
during assembly, creating the risk of personal injury
to your hands and fingers.
• Take care that you do not pinch your fingers
between parts when assembling them.
• When placing the digital piano on the floor, be sure
to place it on something soft (a blanket, cushion,
etc.). Do not place the digital piano directly onto the
floor.
NOTE
• Be sure to follow the proper procedure when
assembling the stand.
PREPARATION
• Pull the pedal unit cable out from the pedal unit
E
.
Unpacking
A
Side panel...........................×1
B
Side panel...........................×1
C
Back board..........................×1
D
Screw caps.......................... ×6
E
Pedal unit ............................×1
F
Screws................................ ×2
G
Clips.................................... ×2
H
Brackets.............................. ×2
I
Screw caps ......................... ×2
J
Screws................................ ×4
A
B
D
H
I
F
G
E
C
J
Assembling the Stand
E
PX780_e.book 59 ページ ２０１２年１２月６日 木曜日 午後２時２６分