Filter
Top Products
Using the Song Sequencer
E-76
You can access the mixer during playback, playback standby,
or record standby (C-3 (RECORD) button flashing), or while
recording is in progress (C-3 (RECORD) button lit). Press the
C-7 (MIXER) button to display the mixer screen. To return to
the song sequencer mode screen, press the C-7 (MIXER)
button again or press the R-15 (EXIT) button.
The table below shows how mixer parts correspond to song
sequencer parts.
Supported Mixer Operations during Playback or Playback
Standby
All mixer settings can be configured during playback or
playback standby, subject to the following precautions.
• If you want to change mixer settings during playback
standby, change them after selecting the song you want to
play back. If you change mixer settings and then change
the song selection, the header settings of the newly
selected song will be recalled and mixer settings will be
changed accordingly.
• The only mixer settings you can change during playback
standby are those that are included in the song header of
the currently selected song. If mixer settings were changed
part way through when recording the song, the later
recorded mixer settings will supersede any settings you
make during playback standby.
Supported Mixer Operations during Record Standby
The mixer settings for the parts shown below (excluding part
on/off) are supported, depending on the track being recorded
to. Settings are recorded to the header settings (page E-71),
the same way settings are stored when recording is started.
Supported Mixer Operations During Recording
Mixer settings cannot be configured during recording to the
system track.
Configuration of mixer settings (except for part on/off) is
supported for a part (B01 through B16) that corresponds to a
track when recording to any track from 01 through 16 shown.
Any change in a mixer setting on the mixer screen is recorded
as soon as it is made.
For details about mixer functions and operations, see “Using
the Mixer” (page E-36).
You can re-record parts of a song you previously recorded in
order to correct errors, etc. Simply enter the record standby
mode and play back the previously recorded song (punch-in
playback) and then play the new notes when playback
reaches the location of the part you want to change.
1.
Press the C-4 (SONG SEQUENCER) button to
enter the song sequencer mode.
2.
Use the dial or the R-14 (–, +) buttons to select a
song area number.
3.
Press the C-3 (RECORD) button to enter record
standby.
• This causes the button to start flashing.
4.
Use the R-17 (u, i) buttons to select the track
you want to partially re-record.
5.
Hold down the C-3 (RECORD) button until the
punch-in/punch-out screen shown below
appears.
Mixer Settings in the Song Sequencer Mode
Mixer Song Sequencer
Parts A04 to A07, A09 to A16 System Track
Parts B01 to B16 Tracks 01 through 16
System Track Tracks 01 through 16
A05 (UPPER 1), A06 (UPPER 2),
A07 (LOWER), A04 (Auto
harmonize) parts
Parts corresponding to
each track
(B01 through B16)
Re-recording Part of a Song
(Punch-in Recording)
To start re-recording from a particular
location during playback (Manual Punch-in)
Mistake
Playback
Use punch-in recording to
re-record only this part.