Filter
Top Products
3
19. Disconnect all power supply before performing
any cleaning, maintenance or relocation of the
unit.
20. When transporting or storing the unit and cord,
keep in a dry place, free from excessive
vibration and store so as to avoid damage
21 If the power supply cord is damaged, it must be
replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a
hazard
22 The heater must not be located immediately
below a socket-outlet
NOTE: Procedures and techniques that are considered
important enough to emphasize.
CAUTION: Procedures and techniques which, if not carefully
followed, will result in damage to the equipment.
WARNING: Procedures and techniques which, if not
carefully followed, will expose the user to the risk of fire,
serious injury, illness or death.
SAVE THESE INSTRUCTIONS
NOTE
A 15amp, 120 volt circuit is required. A dedicated circuit is
preferred but not essential in all cases. A dedicated circuit
will be required if, after installation, the circuit breaker trips or
the fuse blows on a regular basis when the heater is
operating. Additional appliances on the same circuit may
exceed the current rating of the circuit breaker.
WARNING
Ensure the power cord is not installed so that it is
pinched or against a sharp edge and ensure that the
power cord is stored or secured to avoid tripping or
snagging to reduce the risk of fire, electric shock or
injury to persons.
Construction and electrical outlet wiring must comply
with local building codes and other applicable