Filter
Top Products
10
Basic Operation
You can easily get a transition effect when switching images, just by using the MAIN
[1]–[4] buttons.
1. Play back the images with the video equipment.
Input the images from the video device connected to the LVS-400 (such as a video
camera or DVD player).
2. Check the output.
Turn on the video monitor or projector connected to the LVS-400’s output jacks/
connector and check to see whether or not the images are being output correctly.
3. Switch the input channel.
Switch the LVS-400’s input channel. Turn the TRANSITION TIME control knob so
that it points straight up (2 seconds), then press one of the buttons from [1] through
[4] to switch the input.
Check the image on the video monitor or from the projector to confirm that the
images are switched correctly.
Changing the TRANSITION TIME control knob setting allows you to adjust the
amount of time required to completely switch from one image to another.
fig.07
4. Switch the transition effect.
Press the TRANSITION TYPE select buttons and switch the input.
The following effects are available when switching images.
fig.08.e
Switching Images with the Switcher
Start Finish
Start Finish
Start
Finish
MIX: The two images are mixed (overlapped) as they are switched.
WIPE 1: The images are switched by wiping left to right.
WIPE 2: The images are switched with a rectangular wipe starting
from the center of the image.
LVS-400_e1.book 10 ページ ２００４年１月２０日 火曜日 午後１２時５０分