8
Before You Begin
1
Check the power cable.
Make sure that the cable from the AC adaptor is firmly plugged into the LVS-400.
2
Press the POWER button.
Press the POWER button located on the rear panel of the LVS-400. It will take approximately five seconds for the LVS-
400 to initialize itself and begin operating.
fig.04.e
942
* This unit is equipped with a protection circuit. A brief interval (a few seconds) after power up is required before the unit will operate
normally.
1
Press the POWER button.
Press the POWER button located on the rear panel of the LVS-400. All of the front panel LEDs will go dark.
The LVS-400 can be switched to support either NTSC or PAL format signals.
To start up in PAL mode, hold down monitor select “OUTPUT” button and “OUTPUT ON/OFF” button, and press the
power button.
The next time you start up, you can simply press the power button to start up in PAL mode.
If you want to return to NTSC mode, once again hold down monitor select “OUTPUT” button and “OUTPUT ON/OFF”
button, and press the power button.
When the LVS-400 starts up, an indication of whether it is starting up in NTSC mode or PAL mode will appear for several
seconds in the monitor out screen.
Turning the Power On
Turning the Power Off
Switching Between NTSC and PAL