Filter
Top Products
62
Setting up the digital surround processor
To connect to other Meridian 500
Series equipment
● Connect one of the COMMS sockets on the back panel of the
568 Digital Surround Processor to one of the COMMS sockets
on another 500 Series unit, using the 500 comms lead
provided with the digital surround processor.
The sequence in which you connect the units is not important.
568 Digital Surround Processor 500 Series unit
COMMS COMMS
Then configure the units with the following automatic setup
procedure:
● Switch all the units to standby.
● Press Clear (remote).
Each unit will display:
Auto Setup
One unit will then be designated
as the controller, and display:
Controller
This is the unit that will respond to the remote.
All the other units will be configured
as non-controllers, and display:
Not Con.
Your system is now set up and ready for use.
● If for any reason the automatic setup does not give the
configuration you want, restore the default operation by
selecting one of the standard types; see Choosing a standard
setting, page 64.
Note: Do not, under any circumstances, connect any equipment
other than Meridian 500, 600, or 200 Series to the socket
marked COMMS on the back of the digital surround processor.
Connecting to other Meridian equipment