Filter
Top Products
13
VM04 Owner’s manual
0
6
12
24
OL
1234LR1234
MIN
L
R
MAX
VIEW
48
EQ
PAN
LO
HI
EFF
SCENE NO.
LEVEL
CH
MASTER
4. Initial Setting
When you first power up the VM04, the LCD Display will show the following initial setting.
Character section of the LCD Display
It will show <FOSTEX>, <VM04> then,
“Init.Mix”.
Level display
Channel 1 to 4 will indicate the incoming signal
level at the pre-fader position, i.e., it shows the
level regardless of the INPUT Fader setting.
Input channels 1 and 2 have a TRIM
potentiometer (pot) to adjust the gain to cater
for a small signal input such as a MIC. You can
set the appropriate TRIM pot position by
watching the level indicator.
Channels L and R will indicate the outgoing
signal levels at the STEREO OUT L and R
respectively. But, no level indication will be
displayed because you have not yet raised the
MASTER Fader at this stage.
VIEW display
This will show each input channel
setting such as PAN, EQ,
EFFECT SEND and EFFECT
PRE/POST, which you can
choose by pressing the VIEW
key. The setting is also displayed
on the VIEW Status Indicator. In
the initial setting, PAN will be
displayed in the middle of the bar-
graph by two illuminated dots.
See CHANNEL EDIT MODE
(page 15).
Channel Fader display
This section will numerically
indicate the INPUT Fader
position of the channel you
choose in the CHANNEL
EDIT MODE on a range
from 0 to 99. But, there will
be no numbers showing at
the initial setting. See
CHANNEL EDIT MODE
(page 15).
Master Fader display
This part will numerically indicate the
Master Fader position on a range from
00 to 99. The initial setting will show as
00.
Scene Number display
This section will numerically indicate
the Scene Memory number on a
range from 00 to 20. The initial
default setting will be displayed as
00.
If you want the VM04 to return to the factory
default setting completely, follow the
instructions in Item 2-3. RESET.
<Useful info>
When the -10dBV nominal signal level is coming in, the
channel 1 to 4 level meter will indicate -12dB. Also, when the
-10dBV nominal signal level is going out, the channel L and
R level meter will indicate -12dB on the scale.
<Useful info>
You can store your favorite Scene setting on Scene Numbers
from 01 to 20. However, as the Scene Number 00 has been
pre-set by the manufacture. You cannot alter this setting.
VIEW status indicator
When the content to be shown in
the VIEW display is selected with
the VIEW key, the selected dot for
PAN, LO EQ, HI EQ or EFF will
be lit. For details, refer to
"CHANNEL EDIT MODE" in later
page (page 15).