Filter
Top Products
3
VM04 Owner’s manual
Precautions (please read before use)
Power supply
* When unplugging the AC adaptor from the outlet,
be sure to grasp the adaptor. Attempting to unplug
it by pulling on the AC cable may damage the
wiring.
* It is dangerous to use any power cable that is cut
or frayed. If the power cable is damaged,
immediately stop using it, and have it repaired.
* Do not plug in or unplug the AC adaptor with wet
hands. Doing so may result in dangerous electric
shock.
* Do not open the unit or touch any parts inside.
Doing so may result in a dangerous electric shock,
and could damage the unit.
* Do not let water or other liquids, flammable
materials, or metal objects such as pins get inside
the unit. These things may cause electrical shock
or short circuit the VM04, and damage it.
If the VM04 should become wet, unplug the AC
adaptor from the AC outlet, and contact your
authorized service station.
Location
* Avoid using the VM04 in the following locations:
* Locations of extreme low or high temperatures, or
extreme changes in temperature.
* Locations with excessive moisture or dust.
* Locations where direct sunlight falls for an
extended time, or near a stove or other source of
heat.
* Locations where electrical voltage varies.
* Unstable locations or where there is heavy
vibration.
* Near strong magnetic fields (on top of a television
or speaker).
Table of Contents
Precautions..............................................................................3
Let’s examine the VM04 in more detail...........................4
1. Input Section................................................................5
2. Buss Section..................................................................6
3. Master Section.............................................................6
4. Effect Section................................................................7
1. Names and Functions...................................................8
2. Before Use.....................................................................10
2-1. Remove the insulation paper.............................10
2-2. Caution when powering ON...............................10
2-3. Reset........................................................................10
2-4. Internal battery for the memory back up........10
3. Applications...................................................................11
4. Initial Setting..................................................................13
5. Normal Mix Mode.........................................................14
6. Channel Edit Mode.......................................................15
6-1. PAN setting.............................................................15
6-2. EQ Lo setting...........................................................16
6-3. EQ Hi settint............................................................16
6-4. EFFECT SEND setting............................................17
6-5. EFFECT POST/PRE setting...................................17
7. Effect Mode....................................................................18
7-1. EFFECT TYPE setting.............................................19
7-2. EFFECT PARAMETER setting...............................20
Reverb Level setting.................................................21
Reverb Time setting.................................................21
Pre-Delay Time setting............................................21
High Dump setting...................................................21
Early Reflection Balance setting.............................22
8. Scene Memory..............................................................22
8-1. Scene Store.............................................................22
8-2. Scene Recall............................................................23
8-3. Fader Adjust mode...............................................24
8-4. Scene Direct Recall................................................24
9. SETUP Mode.................................................................25
10. Other Modes...............................................................26
10-1. Software Version Check....................................26
10-2. Battery Check......................................................26
Specifications..............................................................................27