Filter
Top Products
Inserts
An Insert incorporates a Jack "send" output and a Jack "return" input. The Insert send/return allows the audio signal
to be routed out of a channel and back into it, after performing some external processing. Inserts are often used to
"patch in" a piece of outboard gear that is not available as a plug-in.
• Measure Latency: Once your insert is connected to a Jack-aware program, or an external piece of gear, then
click this button to measure the latency. If the Insert is used on a track or Mix Bus, this delay will be accommo-
dated automatically.
Outputs
• Add/Remove: adds/removes a Jack port to the insert "send".
• Disconnect All: disconnects all Jack sending ports (does not remove ports)
• Available connections: This is a list of all the available Jack connection ports, with one tab for each Jack appli-
cation, and one for the system sound I/O ("system").
Inputs
• Add/Remove: adds/removes a Jack port to the insert "return".
• Disconnect All: disconnects all Jack return ports (does not remove ports)
• Available connections: This is a list of all the available Jack connection ports, with one tab for each Jack appli-
cation, and one for the system sound I/O ("system").
1122..00 RReeddiirreeccttss:: PPlluugg--iinnss,, SSeennddss && IInnsseerrttss
23
Section 12.0 - Redirects: Plug-ins, Sends & Inserts Mixbus User Guide
Note: Inserts are created "deactivated", you must Activate the insert before it will work.
%