Filter
Top Products
8
Presetting Stations
You can preset up to 30 FM stations and up to 15 AM (MW/LW)
stations.
Note: Preset numbers may have been set to factory test frequen-
cies prior to shipment. This is not a malfunction. You can
preset the stations you want into memory by following one
of the presetting methods below.
Manual Presetting —————————
■
1. Select a band by pressing the TUNER
BAND button.
■
2. Press the 4 or ¢ button to tune in a sta-
tion.
■
3. Press the SET button.
The youngest blank preset number will blink. "P 1" will blink
for the first time.
■
4. Turn the JOG dial to the right or left to
select the preset number.
■
5. Press the SET button.
"STORED" appears and, after 2 seconds, the display returns to
the broadcast frequency display.
■
6. Repeat above steps 1 to 5 for each station
you want to store in memory with a preset
number.
To cancel the presetting, press the CANCEL button in step 3 or 4.
To change the preset stations, repeat the same steps as above.
Auto Presetting ——————————
In each band, you can automatically preset FM-30, AM (MW/LW)-
15 stations. Preset numbers will be allocated as stations are found,
starting from the lowest station and moving up the frequency.
■
1. Select a band by pressing the TUNER
BAND button.
■
2. Press the AUTO PRESET button on the
Remote Control for more than two sec-
onds.
■
3. Repeat steps 1-2 for the other band.
■
If you want to change the preset stations, carry out the Manual
Presetting for the desired preset numbers.
CAUTION: If the System is unplugged or if a pow-
er failure occurs, the preset stations will be
erased after about 24 hours. If this happens, you
will need to preset the stations again.
When you are tuned in an FM broadcast, the "STEREO" indicator
lights up and you can hear stereo effects.
If an FM stereo broadcast is hard to receive or noisy, you can select
Monaural mode. Reception improves, but you lose any stereo effect.
Press the FM MODE button on the Remote
Control so that the "MONO" indicator lights
up on the display.
To restore the stereo effect, press the FM MODE button on the
Remote Control so the "MONO" indicator goes off.
• If you select other FM station, the “MONO” indicator goes out.
Presetting Stations
or
FM=30,AM=15
STORED
When changing the Band
STORED
FM=30,AM=15
When changing the Band
or
or
(for 2 seconds)
or
To Change the FM
Reception Mode
"MONO" indicator goes out. "MONO" indicator lights.
RD-MD5(B)-e.fm Page 8 Wednesday, December 2, 1998 11:40 AM