Filter
Top Products
8 KAWAI DIGITAL PIANO CE200
CAUTION:
To prevent personal injury, do not handle the main unit from the ends.
4. Hold the Back Board (B) behind the Pedal
Board (C) and in front of the fixing metal of
the Side Panels (A).
5. Fasten the Side Panels (A) and Back Board
(B) with two screws (E) on both side of the
instrument (totalling four screws).
6. Fasten the Pedal Board (C) and Back
Board (B) with four screws (F).
(A)
(C)
(B)
(E)
(F)
(D)
(A)
7. The next step requires one person on each end of the main unit.
Grasp the unit with both hands, one under the front, the other under
the rear (remember, not the end) and carefully center the main unit on
top of the stand so that the hook brackets located on the bottom rear
of the main unit are inside the stand side panels (A) and approximately
one-third of the rear, top edge of the side panels are exposed. (See the
illustration to the right)
8. Maintaining a firm grasp under the front of the main, unit slide it
toward the rear of the stand until the hook brackets engage the brackets
at the rear top of the side panels (A). This hook arrangement is design
to prevent the main unit from tilting forward while the screws are
installed. Keep one hand under the front of the main unit, push down
on the front to be certain that hooks are properly engaged.
9. Fasten the main unit and the stand with four screws (D).
(G)
(H)
(C)
(A)
Bottom View
Pedal Unit
(H)
1. Insert the Adjuster (H) on the Pedal Unit.
2. Untie the pedal cable on the bottom of the Pedal Board (C).
3. Fasten the Side Panels (A) and the Pedal Board (C) with five screws (G) on both the left and right
side of the instrument (totalling ten screws).