Filter
Top Products
02: OD/Hyper-Gain Wah
(Overdrive/Hyper-Gain Wah)
121
size4
02: OD/Hyper-Gain Wah
(Overdrive/Hyper-Gain Wah)
This distortion effect has two modes: overdrive and hyper-gain that produces a strong distortion. The
effect also has wah, 4-band EQ, and amp simulator. Compared to the same effect of size 1 and 2, you can
set a higher gain for this effect.
a
Wah Off, On Switches Wah on/off.
☞
P.54
Src None…Tempo Modulation source that controls wah
b Wah Sweep Range –10…+10 Sets the sweep range of wah.
☞
P.54
c
Drive Mode Overdrive, Hyper-Gain Switches between overdrive and hyper-gain distortion.
Pre Low-cut 0…10 Low range cut amount at the distortion input
☞
P.19
d
Drive 1…120 Sets the degree of distortion.
☞
P.19
Output Level 0…50 Sets the output level.
e
Band1 Cutoff [Hz] 20…1.0kHz EQ - Band1 center frequency
Q 0.5…10.0 Band1 bandwidth
☞
P.19
Gain [dB] –18…+18dB Band1 gain
f
Band2 Cutoff [Hz] 50…5.00kHz Band2 center frequency
Q 0.5…10.0 Band2 bandwidth
☞
P.19
Gain [dB] –18…+18dB Band2 gain
g
Band3 Cutoff [Hz] 300…10.00kHz Band3 center frequency
Q 0.5…10.0 Band3 bandwidth
☞
P.19
Gain [dB] –18…+18dB Band3 gain
h
Band4 Cutoff [Hz] 500…20.00kHz Band4 center frequency
Q 0.5…10.0 Band4 bandwidth
☞
P.19
Gain [dB] –18…+18dB Band4 gain
i
Direct Mix 0…50 Mixing amount of dry sound to the distortion
Speaker Simulation Off, On Speaker simulation on/off
j
Wet/Dry Dry, 1:99…99:1, Wet Sets the balance between the effect and dry sounds.
Src None…Tempo Modulation source of effect balance
Amt –100…+100 Modulation amount of effect balance
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
+
Amp Simulation
4 Band PEQ
Output Level
Direct Mix
Pre Low-cut
D
-mod
Wah
Mode: Overdrive / Hyper-Gain
Drive
Driver