Filter
Top Products
22
Input Level
Controls the amount of signal admitted into the process from the input.
Ranges from 0.0dB INV to –90.0dB INV or OFF INV, and from –90.0dB
or OFF to 0.0dB.
Output Level
Controls the amount of post-mix signal emitted onto the output. Ranges
from –90.0dB or OFF to 0.0dB.
vARIoUS PARAMeteRS
The sub-menus that appear below the I/O Settings sub-menu depend on
the active algorithm. Refer to the Parameters section on page 33 for more
information.
Foot PedAL ASSIGNMeNtS
Assign one or more parameters to an optional foot controller here. You can
assign different parameters in each preset, and then change the value(s) of
the assigned parameter(s) by rocking the foot controller forward or back.
Note: When loading a preset with Foot Pedal assignments, the preset will
start with the saved parameter values regardless of the foot pedal’s position.
The foot pedal will change the value after it moves for the first time.
FootSWItch ANd Foot PedAL
FUNctIoNALIty
Your PCM92 has added functionality that lets you change presets using a
footswitch and also change various parameters with a foot pedal (also known
as a foot controller).
PReSet chAINS - hoW to chANGe PReSetS WIth A Foot-
SWItch
You can create sequences of System presets (called preset chains) that you can
cycle through using an optional footswitch. Connect the footswitch to the
Footswitch jack on the back panel using a 1/4” TRS cable. Note that you
must assign functions to the footswitch buttons.
To assign functions to your footswitch buttons:
1. With a footswitch connected to the Foot 1. Switch jack and a System
Preset loaded, press the Select knob. The System menu appears.
2. Highlight Footswitch Setup and press the Select knob.
3. Highlight and select the desired function (Preset Up, Preset Down,
Bypass, or Tap Tempo).
4. Press the desired button on the footswitch to assign it to the this function.
5. Repeat steps 3 and 4 for each button on your footswitch.
To create a preset chain:
1. With any System Preset loaded, press the Select knob. The System menu
appears.
2. Highlight Preset Chain Config with the Select knob, and press the Select
knob.
3. Press Knob A to create a new preset chain.