Filter
Top Products
25
• For reliable communication, it is not recommended to access through satellite Internet or 3G mobile Internet.
4-3 Configuring the Installation App
Press the title bar for 3-5 seconds to enter installer mode.
Step 1. Running the Installation App
Connect mobile device (phone or tablet) to the gateway via wireless connection and run the installation app.
• Default SSID : LGE_EnerBox
• Default password : 87654321
※ When changing SSID, do not include any special characters, symbols or spaces.
※ When running the app via other gateway, please exit the running app.
Step 2. Entering installer mode
MAC Address List (Step 3)
Register Installed AC modules.
AC Module Status (Step 4)
Check conditions of installed AC modules.
Grid Configuration (Step 5)
Check/Change the grid configuration.
System Status
Check conditions of installed solar system.
System Update
Update firmware for the gateway.
System Configuration (Step 6)
Check the Ethernet and set the NTP, web server, service type.
LGE Mode
Engineer-only mode.
[Installer Mode]
• Only certified installers should enter the installer mode.
PV system may malfunction.
CAUTION
After installation of the gateway is completed, you can monitor the solar system by installation app.
To check and configure AC module system, follow the steps below.