Filter
Top Products
ExplanationError Code
Could not load Flash programIE14
Could not start BoxNetIE16
Could not start SerialNetIE17
Could not obtain TCP/IP HostnameIE18
Could not obtain Midi serial socketIE19
Could not start Midi ParserIE20
Could not start Midi Subsystem ManagerIE21
Could not start SubsystemIE22
Could not start Midi Xfer systemIE23
Could not start CASL subsystemIE24
Could not start Externals subsystemIE25
Could not erase System FlashIE26
Could not erase User FlashIE27
Could not autostart Cue ListIE28
Could not start RIF subsystemIE29
Could not start CobraNet subsystemIE30
Could not start DSP subsystemIE31
Could not start Relay subsystemIE32
Could not erase EtherTracks FlashIE33
Could not start TCP/IP subsystemIE34
Could not start SMPTE subsystemIE35
Could not start CueStation 4 serverIE36
These errors are self-explanatory, and indicate a problem with the system software.
Frame Status Error Messages
Some errors are shown as a text message on the Frame Status display.
DMA0 DID NOT INTIALIZE PROPERLY. POWER CYCLE TO CORRECT
DMA1 DID NOT INTIALIZE PROPERLY. POWER CYCLE TO CORRECT
COBRANET DSP HAS STOPPED RESPONDING. POWER CYCLE TO CORRECT
MISSING BOOT ETHERTRACKS FILE. PLEASE SEND FILE
ETHERTRACKS FLASH FAILURE. REFLASH TO CORRECT
ETHERTRACKS DUALPORT FAILURE. POWER CYCLE TO CORRECT
ETHERTRACKS BOOT FAILURE. POWER CYCLE TO CORRECT
MISSING MAIN ETHERTRACKS FILE. PLEASE SEND FILE
ETHERTRACKS STARTUP FAILURE. POWER CYCLE TO CORRECT
CONFIGURATION FOR ETHERTRACKS MISSING. PLEASE SEND CONFIGURATION
COBRANET COMMUNICATION FAILURE. POWER CYCLE TO CORRECT
COBRANET INTERNAL FAILURE. POWER CYCLE TO CORRECT
These errors are non-fatal, but do require a firmware upload or that the LX-300 be rebooted.
44
Frame Status Error Messages