Panasonic AGHMX100PJ Music Mixer User Manual


 
22
Basic Operation
[SETUP] Menu
(Setup Operation) Screen
When the SETUP button is pressed, the [SETUP] menu
screen appears as shown below.
The [SETUP] menu is used to make the basic settings for
the entire unit.
POS.
MODE POWER
RESET
AUDIO INPUT
SETUPVIDEO
AUX
SDI1
WFM
SDI1
VIDEO
1080/59iFORMAT
ASPECT
- -
SETUP
- -
DIRECT
SETUPPATTERN
BUS TYPE
AB
MEMORY INT V
3
TITLE
3
AUDIO CH
SDI1CH
L-CH
1
R-CH
2
OSD
ON
ON
AUDIO SOURCE
CP PAIRFADER
AUX/MIC
PAIR
AUDIO ALIGN.
0dBLEVEL
HEAD
dB*
1
PC1
ANALOG
FORMAT
SXGA
A.SET
PC2 H POSI
30
V POSI
10
PHASE
16
CLOCK
1688
GEN. H PHASE
1000LOCK
FILE EMPTY
1 SAVE
SYSTEM1 TIME
SEC
GPI
ME
SYSTEM2 P.SAVE
OFF
SCR SAVE
10
HOURS M.
OFF
RS-232C B.RATE
9.6k
DATA L.
8BITS
PARITY
NONE PJ
3D MODE
OFF
FORMAT
- -
EVENT
SETUP
ME TIME PATTERN INT
00 E
01:00 F 3021
WHT
X 128
Z 196
Y 128
Scroll the screen to display.
Rotary 1 Rotary 2 Rotary 3 Rotary 4 Rotary 5
*
1
20dB (AG-HMX100P) or 18dB (AG-HMX100E)
Setting the Startup Mode [MODE]
The [MODE] submenu of the [SETUP] menu is used to
specify how to reproduce the stored settings when this unit
is restarted (startup mode).
Rotary 1 Rotary 2 Rotary 3 Rotary 4 Rotary 5
RESET
PRESET
FACTORY
MODE
RESET
POWER
To reset settings other than basic
settings to the factory default settings
when the unit is restarted
Set [POWER] to [RESET] (reset mode) using the rotary 2
control.
Settings other than [SETUP] menu settings, direct pattern
settings, event memory settings, le settings, and key learn
settings are reset to the factory default settings.
To reset all settings to the factory default
settings when the unit is restarted
Reset all settings to the factory default settings.
1
Set [POWER] to [FACTORY] (factory default
mode) using the rotary 2 control, and press the
key.
2
When the message [OK?] appears, press the
key.
To cancel the file save, press the key while
holding down the SHIFT key.
3
When the message “Please Wait…” appears
and then “TURN POWER OFF” appears, turn
off the power and restart the unit.
To restore the last settings when the unit
is restarted
Set [POWER] to [PRESET] (preset mode) using the rotary 2
control.
The following types of data are stored, and applied when
the unit is started next time.
[INT VIDEO] menu setting values
[COLOR EFFECTS], [VIDEO EFFECTS], and [AUDIO
EFFECTS] menu setting values
Combinations of patterns registered as direct patterns
and numbers
Setting values of effects applied to the patterns
registered as direct patterns