Filter
Top Products
14
COMBO INPUT JACK
1/4" and XLR Instrument Input. WARNING: Never plug the output of a power amplier into the input jacks.
Damage may occur to both units.
1/4" TUNER SEND JACK
This Jack is provided for you to connect your tuner directly to your amplier. When the Mute Button (3) is
engaged, the amp is muted but the signal will pass to the tuner.
MUTE SWITCH
This button mutes the power section of the amplier, while keeping the tuner output active. This feature is
switchable via the Ecoustic Series foot controller.
PHASE REVERSE SWITCH
This button reverses the phase of Channel I, which can be benecial in controlling feedback. This feature
is switchable via the Ecoustic Series foot controller.
CHANNEL I GAIN CONTROL
Controls the amount of gain for Channel I.
CHANNEL I GRAPHIC EQ
Nine band graphic EQ. The frequency centers have been optimized for acoustic guitar.
CHANNEL I NOTCH FILTER CONTROL
The notch lter is another tool for controlling feedback. If you are experiencing feedback problems,
adjusting this knob for the correct amount of cut can help stop the feedback. The E110's notch lter is
centered at 450KHz, which can be a problem frequency for acoustic guitar.
CHANNEL II COMBO INPUT JACK
Accepts 1/4" or XLR type cables.
CHANNEL II GAIN CONTROL
Controls the amount of gain for Channel I.
CHANNEL II LOW EQ CONTROL
Controls the amount of low EQ present in the Channel II preamp.
CHANNEL II HIGH EQ CONTROL
Controls the amount of high EQ present in the Channel II preamp.
DIGITAL EFFECTS SECTION
Includes digital reverb, chorus and delay. A complete description of this section is found on page 14.
MASTER VOLUME CONTROL
This knob controls the overall volume of the amplier.
E110 Front Panel
1
2
3
4
5
6
7
8
10
11
12
9
3
1
2
4
5
6
7
8
9
10
11
12
13
13