Filter
Top Products
16
POWER AMPLIFIER SECTION:
Rated Power & Load:
100W into 8 Ohms (internal with DDT
compression)
Frequency Response:
+0, -3 dB, 20 Hz to 20 kHz @
60W(rms) into 8 Ohms
Total Harmonic Distortion:
Less than 0.5%, 1W to 50W(rms),
20Hz to 20kHz, 8 Ohms
DDT Dynamic Range:
Greater than 20dB
DDT Maximum THD:
Below 0.5% THD for 6dB overload
Below 1% THD for 20dB overload
Hum & Noise:
Greater than 90dB below rated power
Power Consumption:
150W, 60 Hz, 120 VAC (domestic)
150W, 50/60 Hz, 220-240 VAC (export)
PREAMP SECTION:
The following specs are measured
@ 1kHz with the controls preset as
follows:
Channel 1 Gain @ 5
Graphic EQ Sliders @ 0 dB
Notch Filter @ 0dB
Channel 2 Gain @ 5
Low EQ @ 0 dB
High EQ @ 0 dB
All Effects Bypassed
Master Volume @ 5
Channel 1 -1/4" Input:
Impedance: High Z, 10M Ohms
Nominal Input Level: -8.40dBV,
380mV(rms)
Maximum Input Level: 3.52dBV,
1.50V(rms)
Channel 1 - XLR Input:
Impedance: Low Z, 8.2k Ohms
Nominal Input Level: -25.1dBV,
55.8mV(rms)
Maximum Input Level: -13.2dBV,
220mV(rms)
Channel 1 - Equalization:
Nine-band, Constant-Q Graphic EQ
Frequency Centers (Hz) at 63, 125,
250, 500, 1k, 2k, 4k, 8k, 16k
Available +/-15dB of boost/cut on
each band
Channel 1 - Notch Filter:
Available 18dB of cut at 150Hz
Channel 2 - 1/4" Input:
Impedance: High Z, 10M Ohms
Nominal Input Level: -8.40dBV,
380mV(rms)
Maximum Input Level: 3.52dBV,
1.50V(rms)
Channel 2 - XLR Input:
Impedance: Low Z, 8.2k Ohms
Nominal Input Level: -25.1dBV,
55.8mV(rms)
Maximum Input Level: -13.2dBV,
220mV(rms)
Channel 2 - Equalization:
Low and High Shelving-type EQ
Corner Frequencies at 80Hz and 8kHz,
respectively
Available +/-15dB of boost/cut on
each
Balanced XLR Line Output (rear):
Output Impedance: 150 Ohms
Nominal Output Level: 3.23dBV,
1.45V(rms)
Available Ground Lift capability
System Hum & Noise @ Nominal Input
Level:
(20Hz to 20kHz un-weighted)
Greater than 75dB below rated power
External Footswitch (not included):
Peavey Part # 03582670
See manual text for functional details
Dimensions & Weight:
18.0” H x 20.7” W x 14.7” D (458mm H
x 526mm W x 374mm D)
45.0 lbs (20.4kg)
ECOUSTIC
®
E110
SPECIFICATIONS