Filter
Top Products
20
MASTER DI GROUND LIFT
Engaging this switch will disconnect the ground connection from pin 1 on the DI output XLR
Jack. Usually this should be left in the "out" position; however, there may be certain situations when connect-
ing from the DI jack to another device that a hum is produced due to a ground loop. If this happens, then press-
ing the ground lift switch in should eliminate the problem.
XLR DI OUTPUT
The XLR jack is a low-impedance, balanced output for connecting directly to a stage box or mixer
for live or studio use.
1/4" LINE OUTPUT
Direct line-level balanced 1/4" output for connecting directly to a stage box or mixer for live or studio use.
STEREO LINK OUT JACK
Connecting this to the Power Amp Input on another Session 300 (5) will complete the stereo image in the ef-
fects section. In this example, this amplier would be the rst amplier and the front-panel controls would be
active.
CHANNEL III RCA INPUT JACKS
RCA type input jacks for connecting outboard gear such as CD players, MP3 players or drum machines to Chan-
nel III of the Session 300.
TRS 1/4" LINE OUT FOR CHANNELS I AND II
Direct line level balanced 1/4" output for connecting either channel directly to a stage box or mixer for live or
studio use. This output is prior to the digital effects section, so the front-of-house engineer can have a pure
instrument signal.
XLR DIRECT INTERFACE FOR CHANNELS I AND II
Low-impedance, balanced output for connecting either channel directly to a stage box or mixer for live or studio
use. This output is prior to the digital effects section so the front-of-house engineer can have a pure instrument
signal.
DI OUTPUT EQ PRE/POST SWITCH FOR CHANNELS I AND II
Switches the channel-specic DI outputs from pre or post EQ source.
DI OUTPUT GROUND LIFT FOR CHANNELS I AND II
Pressing this switch "in" will disconnect the ground connection from pin 1 on the DI output XLR Jack. Usually
this should be left in the "out" position; however, there may be certain situations when connecting from the DI
jack to another device that a hum is produced due to a ground loop. If this happens, then pressing the Ground
Lift Switch should eliminate the problem.
PRE-EQ EFFECTS LOOP SEND FOR CHANNELS I AND II
For sending the signal to an outboard effects processor(s). The Session 300 is equipped with separate effects
loops for channels 1 and 2. This effects send is pre-eq.
PRE-EQ EFFECTS LOOP RETURN FOR CHANNELS I AND II
The signal return from your outboard effects processor(s). This effects return is pre-eq.
TUNER OUTPUT
Connect this to your outboard tuner. When the Tuner/Mute switch is engaged, this output remains active for
quiet tuning. This output could also be used as an auxiliary line output.
6
7
8
9
10
11
12
13
14
15
16
Session 300 Rear Panel
5