Filter
Top Products
18
Session
®
300 front panel
PIEZO SWITCH
The Piezo switch is an EQ specically voiced to remove the "brittleness" that can be present when using a
Piezo pickup in an acoustic guitar. Consult your guitar owner's manual to determine the type of pickup pres-
ent in your acoustic guitar.
GRAPHIC EQUALIZER
These sliders provide precise tone control through the constant-Q, nine band equalizer. Each band may be
boosted or cut 15 dB.
NOTCH FILTER FREQUENCY CONTROL
This knob selects the frequency for the notch lter cut. The range is from 100 Hz to 2 kHz. This control
features a Peavey patent, FLS or Feedback Locating System. There are LED's surrounding the knob which
will light up as feedback is present. This allows the user to see a visual cue as to where the frequency of the
feedback is centered and move the pointer of the knob to that location.
NOTCH FILTER CUT CONTROL
This knob controls the amount of notch for the frequency chosen via the Frequency Control (9).
DIGITAL EFFECTS SECTION
Includes digital reverb, chorus and delay. A complete description of this section is found on page 14.
CHANNEL VOLUME CONTROL
These knobs control the master volume of channels 1 and 2.
CHANNEL III 1/4" INPUT
1/4" Instrument Input.
CHANNEL III INPUT SWITCH
This switch selects which input jacks are being utilized for Channel III. There is a 1/4" input on the front
panel and two RCA-type jacks on the rear panel for using outboard devices such as CD players, MP3 players,
drum machines, etc. For the best performance and lowest noise, this switch should be set to the front 1/4"
input when the RCA jacks are not being used.
CHANNEL III GAIN CONTROL
Controls the input level for Channel III.
CHANNEL III TONE CONTROL
Controls the tone of Channel III. Setting this control to "0" sets the EQ to at. Turning clockwise progres-
sively increases the bass and treble.
HIGH FREQUENCY CONTROL
This knob controls the level of the ribbon high-frequency driver. Turning this knob clockwise will increase the
level of the ribbon driver.
CHANNEL BLEND CONTROL
This control pans between the Channel I and Channel II preamps. This control is benecial when you have
the sound of the preamps how you want them, but need to make ne adjustments to the balance between
the channels. It is also very benecial when using a guitar with both a Piezo and Mic output and you wish to
blend the 2 signals.
MASTER VOLUME CONTROL
Controls the overall volume of the amplier.
10
9
8
7
11
12
13
14
15
16
17
18
19