Filter
Top Products
17
COMBO INPUT JACK
1/4" and XLR Instrument Input. WARNING: Never plug the output of a power amplier into the input jacks.
Damage may occur to both units.
PREAMP MODE SWITCH
The Session 300 has a very special feature that allows for three different modes of preamp operation.
Duet mode: In this mode, both preamps are active simultaneously, as are both inputs. This is so the
user can use an instrument in Channel I while using a microphone in Channel II. You could also use
this mode to have two different instruments playing at the same time, or have dedicated channels and
EQ for two different instruments.
Ch. Switch mode: In this mode, the Channel I input is active, and Channel II is accessed by the channel
switch button on the foot controller or the Channel button in the effects section of the amp. This is to
give you either a solo boost or different EQ settings which you can select via the foot controller.
Link mode: In Link mode, both preamps are active and fed by the Channel I input. You can use this
mode to create interesting EQ curves; use both notch lters for two-band ltering; or create unique
effects combinations by accessing both channel's effects presets. The Blend control (18) can then be
creatively utilized to blend between the 2 channels.
GAIN CONTROL
This knob controls input level of the instrument.
TUNE/MUTE SWITCH
This button mutes the power section of the amplier and all DI's, while keeping the tuner output active.
This feature is also accessible via the optional foot controller.
9V/48V PHANTOM POWER
The Session 300 is capable of sending 9V phantom power via a TRS cable to your guitar if your guitar's
preamp can accept phantom power. Check your acoustic guitar's preamp specications to determine com-
patibility. If your guitar's preamp cannot accept phantom power, use a regular 1/4" instrument cable, NOT
a TRS-type cable. The amplier can also send 48V phantom power to a microphone via an XLR cable. This
feature is available on both channels.
PHASE REVERSE SWITCH
This button changes the phase of the channel, which can be very helpful in controlling feedback. This
feature is also footswitchable via the Ecoustic foot controller.
Session
®
300 Front Panel
1
2
3
4
5
6
5
1
2
3
4
7
6
3
4
5
6
7
1
8 9
8 9
10
10 11
12 13 14 15
16
12
17
18
19