Filter
Top Products
[ 26 ] Pelco Manual C527M-L (3/04)
SWITCH SETTINGS
To set the switches on the keyboard (refer to Figure 11):
ᕡ Remove the two screws and the DIP switch cover plate from the rear of the keyboard.
ᕢ Set the switches:
• Address (Switches 1-4)
Position the switches according to Table B. Each keyboard in the system must have a different address,
including the local keyboard. To make programming easier, address keyboards in ascending order.
NOTE:
CM6700 accepts only eight addresses.
Table B. Keyboard Addresses
Keyboard Switch Settings
1234
1 OFF OFF OFF OFF
2ONOFF OFF OFF
3 OFF ON OFF OFF
4ONONOFF OFF
5 OFF OFF ON OFF
6ONOFF ON OFF
7 OFF ON ON OFF
8ONONONOFF
9 OFF OFF OFF ON
10 ON OFF OFF ON
11 OFF ON OFF ON
12 ON ON OFF ON
13 OFF OFF ON ON
14 ON OFF ON ON
15 OFF ON ON ON
16 ON ON ON ON
• Mode (Switches 5, 7, 8)
Position the switches according to Table C. Switch 6 enables/disables turbo pan. It can be switched
while the keyboard is on.
Table C. Keyboard Modes
CM6700/CM6800** Direct P**
CM6700 ASCII***
CM6800 ASCII*** Direct D*** CM9760-MDA*
Switch 5 OFF ON OFF OFF ON ON
Switch 6 ON or OFF ON or OFF ON or OFF ON or OFF ON or OFF ON or OFF
Switch 7 OFF OFF ON ON ON OFF
Switch 8 OFF OFF OFF ON OFF ON
****Firmware version 4.00 and higher.
****Firmware version 4.20 and higher automatically recognizes CM6700/CM6800 and Direct P Mode.
****Firmware version 5.00 and higher.