Filter
Top Products
Pelco Manual C527M-L (3/04) [ 37 ]
REVISION HISTORY
Manual # Date Comments
C527M 11/97 Original version.
C527M-A 1/98 Revised manual to include Direct Mode Installation/Operation instructions. Added CM6700
Operations instructions.
C527M-B 4/98 Revised installation instructions as a result of hardware changes to the rear panel of the
CM6700 SCU.
6/98 Added Section 1.2, Regulatory Notices, and Section 1.3, Certifications.
C527M-C 9/98 Revised manual to show new DIP switch and switch settings.
C527M-D 4/99 Added references to Service Bulletin 981014 for connection instructions. Revised material
in the sections on programming and operating a camera pattern. Revised manual to new
format.
6/99 Revised the sequence key definitions. Added material on programming Spectra
®
features to
the
Direct Mode Operation
section.
C527M-E 3/00 Added pattern programming and operation in
Direct Mode Operation
section to support
revision 4.0 firmware. Added CM9760-MDA mode.
C527M-F 7/00 Revised format.
C527M-G 10/01 Added information about the CM6800 Matrix Switcher and additional functionality of the
iris keys and joystick.
C527M-H 2/02 Changed to KBD300A. Revised keyboard drawings to reflect key labeling changes.
Several procedures revised because of the labeling change. Revised pattern programming
in Table D to include procedures for Spectra III. Stated that firmware versions 4.20 and
higher automatically recognize CM6700/6800 and Direct modes.
C527M-I 11/02 Added firmware version 5.00 information as per ECO 02-8447. Added three modes to the
Description
and
Installation
sections. Revised Tables A, C, and D. Updated
Specifications
.
C527M-J 12/02 Revised Tables A and D. Removed RS-232 from
Specifications
.
C527M-K 9/03 Added UL certification seal, changed power specification, and corrected zone information.
C527M-L 3/04 Revised directions for direct mode installation. Revised safety instructions. Changed FCC
notice. Removed references to use 18-gauge wire for EIA RS-485 communication.