Filter
Top Products
15
English
Equalizer
Change the high frequency (treble) and low
frequency (bass) settings of the SoundBar.
Press TREBLE +/- or BASS +/- to change the
frequency shown on the display panel.
MP3 player
Connect your MP3 player to play your audio les
or music.
What you need
• An MP3 player.
• A 3.5mm stereo audio cable.
Play music
1 Connect the MP3 player to the SoundBar as
described in the Quick start guide.
2 Press AUDIO SOURCE repeatedly to
select MUSIC I-LINK on the display panel.
3 Press the buttons on the MP3 player to
select and play audio les or music.
iPod or iPhone
When you connect a Philips dock for iPod/iPhone,
you can use the SoundBar to play music, movies
and photos from your iPod or iPhone.
What you need
• A Philips dock (Model: Philips DCK3060).
• A yellow composite cable.
Note
•
Philips dock for iPod or iPhone is sold
separately.
• Charge your iPod or iPhone on the dock while
the SoundBar is in iPod mode.
Dock your iPod or iPhone
1 Move the slide at the bottom of the dock to
STANDARD, and then connect the dock to
the SoundBar.
2 Connect the yellow composite cable to the
dock and TV.
3 Switch on the iPod or iPhone, and place it
on the dock.
Night mode
For quiet listening, decrease the volume of loud
sounds when you play discs. Night mode is only
available for Dolby encoded DVD and Blu-ray
discs.
1 Press SOUND SETTINGS repeatedly to
select NIGHT on the display panel (see
‘Sound options and settings’ on page 14).
2 Press OK.
3 Press the Navigation buttons ( / ) to
select a setting:
• ON: Turn on night mode.
• OFF: Turn off night mode.
Note
•
If auto volume is set to ON, you cannot enable
the night mode.
Synchronize picture and sound
If the audio and video are not synchronized,
delay the audio to match the video.
1 Press SOUND SETTINGS repeatedly to
select AUD SYNC on the display panel (see
‘Sound options and settings’ on page 14).
2 Press OK.
3 Within two seconds, press the Navigation
buttons (
/ ) to change the delay
shown on the display panel.
4 Press OK to conrm.
Ambisound
Set up Ambisound to give the best surround
sound effect.
Press AMBISOUND repeatedly to select a
setting on the display panel:
• AMBISOUND: Surround sound for your
room (see ‘Ambisound’ on page 18).
• STEREO: Two-channel stereo sound. Ideal
for listening to music.
• AUTO: Surround sound based on the audio
stream.
Note
•
If you play a source with DTS, DTS is displayed
on the display panel for two seconds.
• If you play a source with Dolby, DOLBY D is
displayed on the display panel for two seconds.
EN