Filter
Top Products
19
English
8 Wall mount and
stand
Before you mount your SoundBar to the wall or
onto a single stand, read all safety precautions (see
‘Safety’ on page 5).
If you have any query, contact Philips Consumer
Care in your country.
Wall mount
Screw length/diameter
Depend on the type of wall mounting this wall
mount bracket, make sure that you use screws of a
suitable length and diameter.
Note
•
Before wall mount, you can remove the three
rubber feet at the bottom of the SoundBar.
• If you remove the rubber feet, you cannot stick
them back on the bottom of the SoundBar.
For information about how to wall your SoundBar,
see the wall mount guide.
> 25mm
3 - 3.5mm
Display panel
Change the brightness of the SoundBar display
panel.
1 Press SETUP repeatedly to select DISPLAY
on the display panel (see ‘Setup menu
options and settings’ on page 18).
2 Press OK.
3 Press the Navigation buttons ( / ) to
select BRIGHT, DIM 1, or DIM 2, and then
press OK.
Apply factory settings
You can reset your SoundBar to the default
settings programmed at the factory.
In AUX mode, within three seconds, press
TREBLE+, VOL-, and BASS+.
» When the factory settings restore is
complete, the SoundBar automatically
switches off and restarts.
EN