Filter
Top Products
17
English
Play audio from SoundBar
You need to connect an HDMI-CEC device to
the TV and route its audio output from TV to
the SoundBar in order to map the audio of the
connected device to your SoundBar.
1 Press SETUP repeatedly to select AUD
CTRL on the display (see ‘Setup menu
options and settings’ on page 18).
2 Press OK.
3 Press the Navigation buttons ( / ) to
select ON, and then press OK.
• To play the audio from the TV
speakers, select OFF.
4 Press SETUP repeatedly to select TV
AUDIO on the display panel, and then press
OK.
5 Press the Navigation buttons ( / ) to
select the audio output for each connected
device.
• HDMI ARC: Audio output through the
HDMI ARC connection.
• COAX IN: Audio output through the
coaxial connection.
• OPTI IN: Audio output through the
optical connection.
• AUX: Audio output through the AUX
connection.
6 Press OK to conrm.
7 Press EXIT to exit the menu.
Note
•
HDMI ARC can only be selected if you
connect your SoundBar to the HDMI ARC
compliant TV through HDMI ARC connection
(see ‘Option 1: Connect to TV through HDMI
(ARC)’ on page 10).
Control devices
Control the SoundBar and the other connected
HDMI-CEC compliant devices with a single
remote control.
One-touch standby
When you press and hold
(Standby) on
the remote control, the SoundBar and all the
connected HDMI-CEC devices (that support
one-touch standby) switch to the standby
mode.
If One-touch standby is enabled on your
SoundBar, you can switch to standby with the
remote control of the TV or other connected
HDMI-CEC devices.
System Audio Control
You need to connect a device to the TV
and route its audio output from TV to the
SoundBar so that the SoundBar can switch to
the corresponding audio source automatically.
To use one-touch audio, switch on System
Audio Control and map connected devices to
the audio input connectors of the SoundBar.
TV Audio Mapping
You need to connect a device to the TV
and route its audio output from TV to the
SoundBar in order to map the device to the
audio input connector (see ‘Play audio from
SoundBar’ on page 17).
One-touch standby
The SoundBar and all connected HDMI-CEC
devices can be switched to standby by a remote
control.
1 Press SETUP repeatedly to select SYS
STBY on the display panel (see ‘Setup menu
options and settings’ on page 18).
2 Press OK.
3 Press the Navigation buttons ( / ) to
select ON.
4 Press OK to conrm.
5 Press EXIT to exit the menu.
Note
•
To disable One-touch standby, select OFF.
EN