Filter
Top Products
49
Assigning MIDI Messages (EDIT Mode)
Here’s how to assign a note message to a controller. In addition to their use in performance, note messages can also be used to control DAW software.
1 Press the [ACT] button and [ ] button simultaneously.
2 Slightly move the controller to which you want to assign a note
message.
If the controller is a button, press it.
The number of the selected controller will blink in the display.
3 Verify that the display, and press the [ENTER] button.
fig.lcd-note.eps
4 Turn the [VALUE] knob until “NOTE”
appears in the display.
fig.lcd-midichannel
5 Press the [ENTER] button.
The display will indicate the currently
specified MIDI transmit channel.
6 Use the [VALUE] knob to specify the desired MIDI transmit channel.
fig.lcd-notenumber.eps
7 Press the [ENTER] button.
The display will indicate the currently
specified note number.
8 Use the [VALUE] knob to select the desired note number.
9 Press the [ENTER] button.
10 If the controller is [B1]–[B4], [L1]–[L9], [A1]–[A8], or HOLD (P1),
specify the desired “Button mode setting” (p. 55).
* If you assign a note message to [R1]–[R9], [S1]–[S9], or EXPRESSION (P2), setting the
controller to the maximum position will transmit a note message with the specified
velocity value. When you slightly lower the controller from its maximum position, a
note message with a velocity value of 0 will be transmitted.
* If you assign a note message to [B1]–[B4], [L1]–[L9], or HOLD (P1), turning the
controller On will transmit a note message with the specified velocity value. Turning
the controller Off will transmit a note message with a velocity value of 0.
* If you assign a note message to [A1]–[A8], the velocity will change depending on the
force with which you strike the pad.
Note Assignments
MIDI transmit channel Note number Velocity Port Button mode Aftertouch
1–16 0–127 (00–7FH) 100 (64H) (fixed) PORT1 (fixed) UNLATCH, LATCH OFF (fixed)
You can also use the following method to change the note number.
fig.numberbutton_edit.eps
In Edit mode, you can enter a numeric
value by pressing the following buttons.
Controllers [B1]–[B4], [SPLIT]/[DUAL]/
[LOWER]/[UPPER] buttons, OCTAVE [–] [+]
buttons
A-300_500_800C_e.book 49 ページ ２０１０年２月２２日 月曜日 午後９時１３分