Filter
Top Products
29
Recording Your Performance
Stop recording
7.
Press the [Play] or [Rec] button.
Recording will stop, and the indicators for the [Play] and [Rec] buttons will
go dark.
The recorded performance is stored in “USr (User).”
Play back the recorded performance
8.
Press the [Play] button.
You will hear the recorded performance.
Once again press the [Play] button, and playback will stop.
Selecting and Recording the Track
for Each Hand Separately
The recorder of the DP-900 has two recording tracks, allowing you to record
the right and left hands separately. Use the [1] button or [2] button to specify
the recording track.
If you want to re-do the recording, you can re-record just a specific track.
fig.panel4-3
As described in steps 1 and 2 of “Recording a New Song” (p. 27), select “
USr
”
before you continue.
1.
As necessary, turn on the metronome (p. 19).
2.
Press the [Rec] button.
The [Rec] button’s indicator will light.
The button indicators of tracks that are already recorded will light.
The track button for which you will next be recording will be blinking.
Selecting the track to record
3.
Press the [1] or [2] button to select the track that you want to record.
The indicator of the button you pressed will blink, and the DP-900 enters
recording standby mode.
Start recording
4.
Press the [Play] button.
The DP-900 counts down two measures, then recording starts.
Note that recording will also begin as soon as you play anything on the
keyboard, even if you do not press the [Play] button. There is no count sound
played when you start in this manner.
When a recorded
performance is played
b
ack, the metronome
sounds the ordinary
metronome sound.
2, 51
4, 5, 6
3
If you go on to record
additional material
without erasing the
recorded song, the song
tempo, beat, and
metronome settings of the
original recording will be
used for the new material
as well.
The track buttons allow
you to record to either the
[1] or the [2] button, one at
a time.
DP-900_e.book 29 ページ ２００４年１１月２９日 月曜日 午後１２時５８分