Filter
Top Products
7
Introduction
2.
Secure the right side board to the speaker box
with the screws (in two places).
fig.st2.e
3.
Set the stabilizer in the holes in the side boards
(in six places).
fig.st3.e
Take care not to attach the left and right stabilizer to the
wrong sides.
fig.st900SAP
4.
Raise the entire assembly.
When standing the assembled unit up, grasp near the
speaker box and center part of the DP-900, and gently
raise the assembly.
fig.st4
5.
Put the Pedal Board on the stabilizer.
When putting the Pedal Board on the stabilizer, first
loosen the screws securing the speaker box to the side
boards.
fig.st5.e
6.
Secure the Pedal Board to the side boards with
the attachment screws (in two places).
Retighten the screws loosened in Step 5.
fig.st6.e
To stabilize the pedals
Temporarily loosen the screws that fasten the pedal board.
Step on the pedal, and after verifying that the pedal is in firm
contact with the floor, re-tighten the screws firmly.
Attachment screw
Side board right
Stabilizer
screws
Loosen the screws
(in four places).
Pedal Board
Attachment
screws
DP-900_e.book 7 ページ ２００４年１１月２９日 月曜日 午後１２時５８分