Filter
Top Products
Using the MV8-OP1
15
MV-8800 Using the MV8-OP1
■
Transferring audio
■
Remote control using MMC
Settings for each device
Model
Master (output device) Slave
MV-8800
MIXER (INSTRUMENT PART) screen (Screen Guide;
p. 236)
• Output parameter of the part you want to send to
R-BUS: MLT1–8, M1/2–M7/8
R-BUS screen (Screen Guide; p. 183)
• R-BUS Word Clock parameter: Internal
GLOBAL screen (Screen Guide; p. 173)
• Input Select parameter: R-BUS
R-BUS screen (Screen Guide; p. 183)
• R-BUS Word Clock parameter: External
VS-2480CD/
VS-2400CD
PROJECT PARAMETER screen
• MASTER CLOCK parameter: INT
OUTPUT ASSIGN screen
• Connect the bus you want to output via R-BUS to
R-BUS (1/2–7/8)
PROJECT PARAMETER screen
• MASTER CLOCK parameter: R-BUS
PATCH BAY screen
• Connect R-BUS 1 or 2 to the INPUT MIXER.
You must first load a 44.1 kHz project or create
a new one.
RPC-1
• MASTER CLOCK parameter: Int. Clock • MASTER CLOCK parameter: Ext. Clock
VM-7000
series
SYS DIGITAL screen
• WORD CLOCK SOURCE parameter: INTERNAL
EZ ROUTING - MULTI IN screen
• In the patch bay, connect the signal from R-BUS to
the multi in mixer.
SYS DIGITAL screen
• WORD CLOCK SOURCE parameter: MULTI 1-8 /
MULTI 9-16 / MULTI 17-24
EZ ROUTING - MULTI IN screen
• In the patch bay, connect the signal from R-BUS to
the multi in mixer.
Model
Master (controlling device) Slave (controlled device)
MV-8800
SYNC screen (Screen Guide; p. 81) or
PATTERN SYNC screen (Screen Guide; p. 94)
• MMC Mode parameter: Master
• MMC R-BUS parameter: On
SYNC screen (Screen Guide; p. 81) or
PATTERN SYNC screen (Screen Guide; p. 94)
• MMC Mode parameter: Slave (R-BUS)
VS-2480CD/
VS-2400CD
MIDI PARAMETER screen
• MMC MODE parameter: Master
MIDI PARAMETER screen
• MMC MODE parameter: SLAVE
• MMC SOURCE: R-BUS
RPC-1
• In your sequencer software, set the MMC
parameter to Master.
• In your sequencer software, specify the RPC-1 as
the device that will transmit MMC.
• In your sequencer software, set the MMC
parameter to Slave.
• In your sequencer software, specify the RPC-1 as
the device that will receive MMC.
VM-7000
series
SYS SYNC/MMC screen
• MMC CONTROL parameter: ON
• MMC MASTER parameter: INT
SYS MIDI screen
• Tx PARAM parameter: ON
SYS SYNC/MMC screen
• MMC CONTROL parameter: ON
• MMC MASTER parameter: MULTI 1-8 / MULTI
9-16 / MULTI 17-24
SYS MIDI screen
• Rx PARAM parameter: ON
MV-8800_b_MV8OP1_e.fm 15 ページ ２００６年１２月６日 水曜日 午後１時１１分