Filter
Top Products
8
MV-8800 Using the MV8-OP1
Using the MV8-OP1
1.
Connect the MV-8800 with your output destination device.
2.
Press [MIXER].
The MIXER (AUDIO TRACK) screen (Screen Guide; p. 235) will appear.
3.
Set the Output parameter to MLT1–8 or M1/2–7/8.
Set the Output parameter of the part whose signal you want to send to the multi outputs. The signal sent to
each output will be output via the analog multi output.
The MV-8800 has both coaxial and optical type digital input connectors. You must choose either one or the
other type. You cannot use both simultaneously.
1.
Connect your digital audio device to the MV-8800.
2.
Press [SYSTEM].
The SYSTEM MENU screen (Screen Guide; p. 172) will appear.
3.
With the cursor located in the upper row of icons, press [F1](Global). Alternatively, select
the GLOBAL icon and press [ENTER].
The GLOBAL screen (Screen Guide; p. 173) will appear.
4.
Set the Input Select parameter to either “Coaxial” or “Optical.”
Select “Coaxial” if you want to input from the coaxial connector (DIGITAL IN A), or select “Optical” if you want
to input from the optical connector (DIGITAL IN B). When you change the setting, the illustration of the input
connector in the GLOBAL screen will also change.
Outputting analog audio from analog multi output
Value
Destination bus Analog multi output
MLT1
Multi output 1 1
: : :
MLT6 Multi output 6 6
MLT7 Multi output 7 Not output
MLT8 Multi output 8 Not output
M1/2 Multi output 1/2 1 and 2
M3/4 Multi output 3/4 3 and 4
M5/6 Multi output 5/6 5 and 6
M7/8 Multi output 7/8 Not output
●
The audio signal of multi output 7 and 8 cannot be output via analog multi output.
Inputting audio via a digital connection (coaxial/optical)
MV-8800_b_MV8OP1_e.fm 8ページ ２００６年１２月６日 水曜日 午後１時１１分