Filter
Top Products
Installing the MV8-OP1
5
MV-8800 Using the MV8-OP1
1.
Turn off the power of the MV-8800 and the connected devices, and disconnect all cables from
the MV-8800.
2.
Turn the MV-8800 upside down, and lay it on its face supported by objects at each corner so
that the panel buttons and knobs are not damaged.
3.
Remove sixteen screws from the bottom panel
and two screws from the MV8-OP1 slot cover at
the locations shown in the illustration, and
detach the bottom cover and the slot cover.
4.
Insert the MV8-OP1 into the slot in the
orientation shown by the illustration.
5.
Plug the flat cable extending from the MV8-OP1
firmly into the connector on the main board of
the MV-8800.
6.
Use the two screws to fasten the MV8-OP1.
7.
Use the sixteen screws to fasten the bottom
cover as it was originally.
MV8-OP1 installation procedure
●
Be careful not to cut your hand on any sharp edges of the installation slot, cover, or circuit board.
●
When you lay the MV-8800 on its face, make stacks of magazines or newspapers to support each of the four
corners so that the weight of the unit does not damage the buttons and knobs. Make sure that no pressure is
being applied to any button or knob.
1
2
3
4
5
6
7
8
10
11
12
13
14
15
16
9