Roland SD-50 Music Mixer User Manual


 
37
Installing the Driver
7. Check to make sure that MIDI transmission and reception takes place normally.
1. Click “Test Setup.”
2. Turn down the SD-50’s volume.
The following step will cause a fairly loud sound to be produced from the SD-50.
3. Click the SD-50’s downward arrow.
If the SD-50 produces sound, the settings are correct.
fig.XXXXXXXXXXXXX
4. Click “Test Setup” once again to end the test.
8. From the [Audio MIDI Setup] menu, select [Quit Audio MIDI Setup] to finish making settings.
Click
Click
Caution when recording or playing back with your software
Check the following points before you use the SD-50 to record or play back.
Connect the SD-50 to your Macintosh before you start up the software you’re using.
Do not disconnect the SD-50’s USB cable from your Macintosh while your software is running. Close
the software you’re using before you disconnect the SD-50’s USB cable from your Macintosh.
The SD-50 will not work with the Mac OS X Classic environment. Use the SD-50 when the classic
environment is not running.
SD-50_e.book 37 ページ 2010年1月25日 月曜日 午前10時52分