Filter
Top Products
47
Troubleshooting
Deutsch Français Italiano Español Português NederlandsEnglish
Cross Stick Does Not Work
❏ Are you playing the cross stick correctly?
→ Playing cross stick on electronic drums is a bit different. Be
sure your hand or stick does not strike the head also (p. 13).
❏ Is the Xstick Volume set to “OFF”?
→ Set the Xstick Volume to a value other than “OFF” (p. 29).
No Metronome Sound
❏ Is the metronome volume level set to “0” ?
→ Set the metronome Volume to a value other than “0” (p. 34).
No Ambience Applied
❏ Is the Ambience set to “OFF” ?
→ Set the Ambience to a value other than “OFF” (p. 30).
❏ Is the Ambience Depth set to “0” ?
→ Set the Ambience Depth to a value other than “0” (p. 30).
Sound in Headphones Distorted
❏ Sometimes, setting the output too high
certain tones can the sound seem distorted.
→ Turn down the [VOLUME] knob. This will reduce the distortion.
Output Sound is Distorted
❏ Depending on the instrument settings, some
slight distortion may occur in the sound.
→ In the drum kit settings, adjust the mixer Pad Volume (p. 29).
→ You can suppress distortion by setting the pan near the
center. In the drum kit settings, adjust the mixer pan setting
(p. 29).
No Sound/Low Volume from Source
Connected to the MIX IN Jack
❏ Could you be using a connection cable that
contains a resistor?
→ Use a connection cable that does not contain a resistor.
❏ Check the volume level of the connected audio
source.
→ See the owner’s manual for the device if there’s a problem.
To adjust the volume of the device connected to the MIX IN
jack, use the controls of the connected device.
Can’t play the sound module connected to
the MIDI OUT connector
❏ Is the MIDI cable connected correctly?
→ Connect the cable to the MIDI IN connector of the external
MIDI sound module.
❏ Is the MIDI channel set correctly?
→ In order to transmit MIDI messages to an external MIDI sound
module, both devices need to be set to the same MIDI channel
(p. 41).
❏ Have you specified the correct note number
for the pad?
→ Set the pad’s note number to a value other than “OFF” (p. 41).
→ Make sure that the pad is set to the same note number as the
sound on your external MIDI sound module.
The note numbers can be specified independently for each kit.
Others
❏ Settings are not saved
→ There is no “Save Settings” operation on the TD-4 itself. The
settings you modify are saved when you turn off the power.
Be sure to turn off the power by pressing the [POWER] button.
❏ Screen display is difficult to read
→ After you’ve turned on the power, press the [MENU] button →
SEL ] button → [OK] button in that order, and use the [-/+]
dial to adjust the contrast (p. 37).
TD-4_e.book 47 ページ ２００８年１１月５日 水曜日 午後６時４０分