Filter
Top Products
Once the connections have been completed (p.6), turn on power to your various devices in the
order specified. By turning on devices in the wrong order, you risk causing malfunction and/or
damage to speakers and other devices.
<Procedure>
❶ Before you turn the power on, check to make sure that:
All external devices are correctly connected to the XP-80.
The volume controls of the XP-80 and the amp/mixer system are turned down all the way.
No disk is in the floppy disk drive.
❷ Turn on the power switch located on the rear panel of the XP-80.
✳ This unit is equipped with a protection circuit. A brief interval (a few seconds) after power up
is required before the unit will operate normally.
❸ Turn the power on of your amp or audio system.
❹ Play the XP-80 and gradually raise the volume controls of the XP-80, your amp or mixer to an
appropriate volume level.
✳ Be careful not to raise the VOLUME slider of the XP-80 too much. Excessive volume may dam-
age your amp/speaker system or could cause hearing problems.
To turn power off
<Procedure>
❶ Before you turn power off, check to make sure that:
The volume controls of the XP-80 and the amp/mixer system are turned down all the way.
No disk is in the floppy disk drive.
Important data has been saved to a disk (p.32).
❷ Turn off your amp/mixer system.
❸ Turn off the XP-80 power.
POWER
VOLUME C2C 1
7
Turn the power on