Filter
Top Products
9
ENGLISH
C/ROOM + PHONES
The C/ROOM + PHONES control is used to set the level sent to the control room outputs, and also to the head
-
phone jack.
+48V - Phantom Power LED
The +48V LED illuminates indicating that the 48 volt
phantom power is applied to the microphone pre-amps
enabling use with condenser microphones.
The +48V LED will light up when the Phantom Power
switch (located on the rear panel) is switched to the ON
position.
POWER LED
The Power LED lights up to indicate that the main
POWER switch (located on the rear panel) is on.
Output Level Meter
The OUTPUT LEVEL METER allows you to monitor the
level of the signal which is being sent to the MIX OUT
jacks.
NOTE: To avoid distortion, adjust the L/R faders so that
the 0 indicator LED lights occasionally.
MIX/2T
The MIX/2T switch selects the signal source that you are
monitoring in the CONTROL ROOM and HEADPHONE
outputs. When the switch is in the up position, the sig
-
nal source is from the LEFT/ RIGHT MIX bus. When the
MIX/2T switch is in the down position, the signal source
is from the 2-TRACK input.
L MIX R
The master MIX level controls are the overall volume
control for the MIX bus. The MAIN level affects both the
Control room signal which is output to the speakers and
the line level signal which is output from the MIX OUT
jacks.
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
14
Controls and Functions
MASTER SECTION
12
16
17
15
15
13
12
13
14
16
17